X-Plane12 Installation and Configuration
Please note that X-Plane12 with ToLiss is currently not officially supported by VIER IM POTT. Nevertheless we want to share our current knowledge with you.
Overview
This document describes how to configure the installed software so that all components work together and the most important basic settings are available. Please note that depending on the configuration of the simulator, other performance settings may also be useful.
Preconditions
Before you start make sure that your computers have an up-to-date Windows 11 installed, you have alle necessary software installed and you did all wiring of displays and USB connections. You will also need a stable internet connection. Ideally you have all computers be placed at its final position in the room, so you do not need to unplug cables any later again.
This document describes how to configure the installed software so that all components work together and the most important basic settings are available. Please note that depending on the configuration of the simulator, other performance settings may also be useful.
Installation X-Plane 12
Install X-Plane 12. Though the following screens are in German installation is pretty simple. Please don't change the default installation path.
Create your personal account at X-plane.
Installation Skalarki Profiler with JPP Plug-in
Please note that you need to do some additional steps to prepare the Skalarki Profiler for the use with X-Plane12.
Install the Skalarki Profiler (= hardware driver) according to the screens below.
Don't be confused about X-Plane 11 headline. Choose ToLiss A320.
This is the JPP configuration window.
Adding Displays on a second PC
Please use the separate Application for this. We recommend reading the local instructions.
Make sure you configure the right IP-address of your secondary PC in the UDBConfig.xml in your main computer.
X-Plane12 Performance Settings
Please note that depending on the configuration of the simulator, other performance settings may also be useful.
Please note that projection setup with warping and edge blending is covered by a separate document.
Please continue with calibration of the flight controls.
