Projection Area (Standing)
Overview
This document describes the installation of the standing version of our projection screen.
These instructions apply equally to Cockpit Builder and Premium Plug & Fly.
You need two people to set up the projection screen.
Height adjustment
The following graphic should help you to determine the correct height of the screen.
Montage
The following sketches show the basic principle of the projection area.
Attach the blocks and the base plates to each support.
Be careful when tightening the screws, otherwise the thread may be damaged.
Attach the blocks and the base plates to each support.
Insert the screen with the keder strip into the profile.
Wait at least two days at room temperature until the canvas is largely wrinkle-free!
Attach the lower profile.
Fit the brackets and the vertical profiles. In some cases it is necessary to shorten the vertical profiles. However, be sure to wait until the canvas has smoothed out at room temperature before doing this. Do not stretch the canvas too tightly.
We recommend fixing the projection surface to the floor.